|
 The Lansmont Model 95/115 Shock Test System has the ability to test items weighing up to 2,500 lbs. (1,134 kg) with a footprint dimension up to 37.4 inches by 45.3 inches (95 cm x 115 cm). It can perform a wide variety of shock tests to a maximum acceleration of 600 g. The Model 95/115 consists of a one-piece cast aluminum shock table that is precisely guided by two solid steel, chrome-plated guide rods. The two guide rods are rigidly attached to a massive, isolated steel base that helps to attenuate any shock energy that would otherwise be transmitted to the surrounding building through the laboratory floor. Also mounted to the steel base are two Damage Boundary Programmers, which allows the operator to generate both half sine and trapezoidal shock pulse waveforms. The Model 95/115 is equipped standard with Lansmont's NEW TouchTest Shock II Controls.
At the start of a shock test an electric hoist raises the shock table until it reaches the programmed drop height, which was easily preset by the operator using the NEW TouchTest Shock II Controls. Once the operator safely initiates the drop sequence, the lifting hook swings clear of the shock table and the two redundant brakes systems release allowing the shock table to free fall. The shock table impacts the Damage Boundary Programmer, creating the desired shock pulse waveform. As the shock table rebounds the hydropneumatic brakes reengage to prevent any secondary impacts.
 |
|
Table Size:
|
37.4" x 45.3" (95cm x
115cm)
|
|
Maximum Specimen Weight:
|
2,500 lbs. (1134 kg)
|
|
Brakes:
|
Hydropneumatic rebound brakes
|
|
Hoist:
|
Dual electric hoist lift system
|
|
|
|
TouchTest Shock System Controller
|
|
|
